Registration Tool

The Registration tool automatically aligns two or more point clouds, providing a rough alignment between them.

Step 1: Target Selection

Click on the wrench icon to access the alignment tool
Select one or multiple point clouds you wish to align (choose a primary point cloud, either dedicated or georeferenced, to serve as the anchor for aligning all other point clouds)
Click “Next” to proceed with Step 2

Step 2: Source Selection

Step 3: Data Filtering

Select the desired tool for point selection from the available options
- None (Rotation)
- Box Selection; left-click + hold and drag mouse across the screen in desired area
- Polygon Selection; left-click to select multiple points on point cloud for the desired area – close or finish Polygon by clicking on the first point again
- Lasso Selection; left-click + hold and drag mouse to enclose the desired area
Click on the Reset icon in Selected Points Action to revert and undo previous selections
Click on “Next” to proceed with Step 4

Step 4: Processing

This step may take a few minutes. Once it is finished, a green check mark will appear indicating successful processing.

Step 5: Analysis

This section functions as a tool for comparing alignment steps and for undoing and redoing actions.

Choose between «Show selected areas only" or the entire content
Toggle the wireframe view by clicking on the checkbox next to "Use wireframe view for models"
To complete the alignment, click "Save" or alternatively, use the "X" on the top right corner of the Registration tool box to close the tool and delete the entire alignment

Navigation menu